The Last One. Until about 2050.

A well-kept system lasts 15 to 25 years, so we design for the long run: sized from a 3D scan of the house, every design reviewed by the owner, installed by our own crew, permitted and inspected.

Day & Night Elite Dealer · Mitsubishi Electric Diamond Contractor

Instant estimate

See your number before anyone visits.

Tap a few answers about the house. You'll see installed prices for real equipment, built from the same books we quote from, with sales tax and a monthly figure.

  • Permit and installation included
  • Sales tax by ZIP
  • Monthly payment shown

Your home

Start with your ZIP. The rest unlocks from there.
We serve King, Snohomish and Pierce counties.
Your price is ready.

Add your name and phone number to see it.

We'll only contact you about your price. Never shared.

Home size
How is the home heated now?
How old is your current system?
A good guess is fine.
What matters most to you?
Pick up to two. We'll recommend the option that fits.

Your estimate

Narrow it down Recommended A few quick questions so we can size your system and tighten your price. Answer the questionsClose
Ceiling height
When was the home built?
Size of your current outdoor unit
Find 18, 24, 30, 36, 42, 48 or 60 in the model number on its label. 24 means 2 tons, 36 means 3.
Your electric company, for rebates
Matched to your ZIP. Change it if your bill says otherwise.

Why a range

The low end is a straightforward replacement that reuses your refrigerant lines and wiring. The high end adds new refrigerant lines, a new electrical circuit, a condensate pump and more install time. We find out which at the visit.

What's included

Equipment, installation by our own crew, the permit, a fused disconnect with surge protection, and startup. Your final price comes after a free in-home visit, a 3D scan of the house and a room-by-room load calculation. Thermostats and thermostat wiring are priced separately.

Rebates

Each option lists the rebates it qualifies for at your address, with the amount and who qualifies. Income-qualified amounts are shown separately. Rebates are not taken off these prices. We confirm what you qualify for and handle the paperwork with you.

Running costs

Estimated for your home's size and age from the system's rated efficiency, your utility's current rates and 30 years of local weather. Real bills vary with thermostat settings and weather, and utilities have asked to raise rates in 2027.

Warranty

Ultimate, our top tier, carries a labor warranty that matches the factory warranty: 5, 7, 10 or 12 years, depending on the equipment. Every other option includes a 2-year labor warranty. The 12-year No Hassle Replacement applies only to top-of-the-line Day & Night equipment.

Book a design consultation

Let's see the house.

Book online for a repair or a free estimate on a new system. Or send the request here, and your instant estimate comes along with it.

Book online in about two minutesPick your own time for a repair or a free estimate.Book online

Prefer to call? (425) 331-9210, answered 24/7

We'll use your details only to schedule and follow up on this estimate. No pressure, no auto-dialer.

12-year No Hassle Replacement · top-of-the-line equipment

Year 9. Compressor fails. You get a new unit.

Year 1Year 9 · replaced, not repairedYear 12
  • Compressor · covered
  • Coil · covered
  • Heat exchanger · covered

On our top-of-the-line Day & Night equipment, if the compressor, coil, or heat exchanger fails in the first 12 years, you get a replacement unit, not a repair. It comes only with that top tier, and it runs 12 years instead of the standard 10 because we're a Day & Night Elite Dealer.

Labor warranty · Top tier: matches the factory warranty, 5, 7, 10 or 12 years · Essential and Advanced: 2 years

We're not the cheapest. We're not trying to be.

If you want the lowest-priced furnace in Seattle, we're not your company, and we'll tell you that on the phone to save you the visit. If you want a system sized from a 3D scan of your house, installed by our own crew, and done once, you're in the right place.

Most of our systems, installed, with sales tax $13,700 to $27,400

Furnace replacements start at $6,500; high-efficiency furnaces around $9,300, sales tax included. The number depends on your house, not on how hard you negotiate.

Alex Yi, Owner

Alex

alex@

Owner

One Hour · Seattle
Alex Yi, Owner
Devan Amling, Director of Operations

Devan

devan@

Director of Operations

One Hour · Seattle
Devan Amling, Director of Operations

The team

Every design crosses the owner's desk.

Before I started this company, I was a Solutions Architect at AWS. Sizing a heating system is a systems problem: your house's heat loss, your ductwork, your electrical panel, and the way you actually live in the rooms. So every design starts with a 3D scan of the house and a room-by-room load calculation built from it. Devan Amling, our Director of Operations, or one of our senior Design Consultants comes out for the visit, and I review every design before you see a price.

We're locally owned, not a private-equity rollup. I stand behind our workmanship warranty, and if something goes wrong after the install, you can reach me directly.

Owner
Alex Yi, former AWS Solutions Architect
Design consultations
Devan Amling or a senior Design Consultant
Sizing
LiDAR 3D scan and ACCA Manual J, room by room
Technicians
Certified
Dealer status
Day & Night Elite Dealer · Mitsubishi Electric Diamond Contractor
Electrical
Washington electrical administrator
Ownership
Local, owner-operated

Alex Yi, Owner

Honest pricing

Here's what things actually cost.

Installed, permitted, and covered by our workmanship warranty. Your exact number comes from the design consultation.

Tier 1

Essential

From $6,500installed, with sales tax

A Day & Night furnace or a single-zone ductless heat pump. Properly sized, permitted, commissioned, with a 2-year labor warranty.

Best forA straight replacement done properly, or one room that needs its own system
Tier 2Most Seattle homes

Advanced

From $13,700installed, with sales tax

A Day & Night variable-speed heat pump, or Mitsubishi multi-zone where ductless fits. Cold-climate rated, MERV 13, duct sealing.

Best forMost Seattle homes replacing a 15 to 25-year-old gas furnace and adding cooling
Tier 3

Ultimate

From $27,400installed, with sales tax

Mitsubishi Hyper-Heat or Day & Night variable-speed, zoned. Fresh-air ventilation, duct redesign, panel work, and top-tier equipment with a labor warranty that matches the factory warranty. Maintenance included.

Best forOlder or larger homes, full electrification, remodels

What moves the number

Square footage and heat loss, number of zones, ductwork condition, electrical panel capacity, equipment tier, line-set runs and placement.

What doesn't

How many quotes you got or what day you sign.

Authorized for the equipment we install

Day & NightElite Dealer
Mitsubishi ElectricDiamond Contractor

The 12-year No Hassle Replacement on our top-of-the-line Day & Night equipment comes from the Elite Dealer program.

Price my house

Real equipment, installed prices and sales tax, plus a monthly figure.

The design consultation

Not an estimate. A design.

The instant estimate gets you close. At the design consultation, Devan or one of our senior Design Consultants scans your house in 3D, and you leave with a firm price.

Most quotes are sized by rule of thumb, or by matching the old unit. We measure: a LiDAR scan of every room, and an ACCA Manual J load calculation built from the scan.

Your furnace may have years left. If it does, we'll say so, in writing. Every design starts with a 3D scan and a load calculation. Sometimes the answer is a repair.

  1. 01Scan the house in 3D with LiDAR (Conduit Tech) and build a room-by-room ACCA Manual J load calculation from the scan.
  2. 02Inspect ductwork, returns, the electrical panel, and where equipment can go.
  3. 03Walk through three options with real prices and the math behind each.
  4. 04Send a written proposal with photos the same day. The price holds for 30 days.
Book a design consultation

No same-day pressure. Decide on your schedule.

Rebates, the honest version

What's real in 2026

Federal heat pump tax credit, $2,000 Ended for systems installed after December 31, 2025

If a company is still advertising the federal credit, ask them to put it in writing.

What's still available depends on your electric utility. Seattle City Light, PSE, and Snohomish PUD each run heat pump rebates with their own equipment and contractor rules, and Mitsubishi runs seasonal instant rebates in the spring. We confirm what your address qualifies for before the visit and file the paperwork for you.

Already have a quote?

Send it over. Alex, our owner, or Devan, our Director of Operations, reviews it line by line, no visit required, and tells you whether it's sized right and priced fairly.

Get a second opinion

FAQ

Common questions

Do you offer financing?

Yes, with approved credit. The plans we offer:

  • 5.99% APR for 3 years.
  • 9.99% APR for 7 years.
  • Up to 10 years at 9.99% to 17.99% APR, based on credit.
  • 12 months, no interest if paid in full. Monthly payments start right away. If the balance isn't paid in full within 12 months, interest at 17.99% APR is charged from the purchase date and payments continue over 7 years.
  • Deferred payments and deferred interest, 6 or 12 months. Nothing is due during the promotional period, and no interest is charged if you pay in full before it ends. If a balance remains, interest at 17.99% APR is charged from the purchase date and the balance is paid over 7 years.
  • Low monthly payment. About 2% of the amount financed each month, at 6.99% to 17.99% APR over 65 to 98 months.

Rates and terms are set by the lender and can change. We go over them at the visit if you want them. We don't lead with financing because it's a payment method, not a reason to buy.

How do you size the system?

From a 3D scan, not a rule of thumb. At the design consultation we scan your house with a LiDAR scanner (Conduit Tech) and build an ACCA Manual J load calculation from the scan, room by room. Most quotes are sized by square footage or by matching the old unit. An oversized system short-cycles, runs louder and wears out sooner; an undersized one can't keep up in a cold snap.

Do I need a backup furnace?

Not always. If you heat with gas now, we usually recommend a heat pump with a new high-efficiency furnace as backup for the coldest days. A cold-climate heat pump can also go all-electric. The instant estimate prices both.

Will it be loud?

Not very. Day & Night's Ion variable-speed heat pump runs as low as 55 decibels outdoors, and Mitsubishi Hyper-Heat outdoor units as low as 54. Mitsubishi's indoor wall units run as low as 21 decibels, quieter than a whisper. We place and mount outdoor units for your lot, not where the old unit happened to sit.

Will my panel handle it?

Often yes. If not, our electrical administrator designs the panel work and it's in the proposal, not a surprise on install day.

What brands do you install?

Day & Night, Mitsubishi, and American Standard for heat pumps, Day & Night for furnaces, Durastar and Ameristar where they fit the design. We're a Mitsubishi Electric Diamond Contractor and a Day & Night Elite Dealer. As an Elite Dealer, our top-of-the-line Day & Night equipment carries a 12-year No Hassle Replacement Limited Warranty through us instead of the standard 10.

What does No Hassle Replacement mean?

If a major component (the compressor, coil, or heat exchanger) fails during the coverage period, the manufacturer replaces the unit instead of repairing it. With us, the 12-year No Hassle Replacement comes only with top-of-the-line Day & Night equipment. Entry-level products don't carry it at all, so ask any contractor which model number they quoted.

How long is your labor warranty?

It depends on the tier you choose. Essential and Advanced systems include a 2-year labor warranty. On Ultimate, our top tier, the labor warranty matches the factory warranty on that equipment: 5, 7, 10 or 12 years. Your estimate shows which applies to each option.

How long does an install take?

1 to 3 days for most systems. We cover floors, clean up daily, and leave the permit record with you.

Where do you work?

Seattle and the surrounding King, Snohomish and Pierce County communities.